Midian Encryption Programming and Service Manual
TM8000 Encryption
53
June 2006
© Tait Electronics Limited
Note
The encryption-enabled TM8200 has customised programming
software 2434A212..
4.5
Encryption-Enabled TM8000 Operating Instructions
TM8100
Note
Encryption changes to standard TM8000 firmware mean that the
TM8000 encryption functions operate similarly to the TOP
encryption interface in these radios.
An encryption-enabled TM8100 radio operates as standard, with the
exception of the following:
■
Press F1 button to enter (or exit) encrypt mode. Green LED above F1
lights.
■
Long-press F1 to enter code-change mode. The current encryption
code is only displayed when the radio is in code-change mode (flashing
SCXX
where XX represents the two-digit code number).
■
Use channel change up/down buttons to change code.
■
Use F1 to exit code-change mode and enter selected (flashing) code. If
no further buttons are pressed, display reverts to channel display and
enters displayed (flashing) code after approximately eight seconds.
TM8200
Note
Encryption changes to standard TM8000 firmware mean that the
TM8000 encryption functions operate similarly to the TOP
encryption interface in these radios.
An encryption-enabled TM8200 radio operates as standard, with the
exception of the following:
■
Press F1 button to enter (or exit) encrypt mode. Green LED above F1
lights and display shows key
icon (top left of display). The current
encryption code (SCXX where XX represents the two-digit code
number) is permanently displayed at bottom left of display, whether in
encrypt mode or not.
■
Long-press F1, or use the left scroll key to enter code-change mode.
■
Use channel change up/down buttons to change code and right scroll
key to select the code.
Menu selection
■
To access Encryption ON/OFF via the menu:
MENU>RADIO SETTINGS>FUNCTION SETTINGS>ENCRYPTION
■
To access Encryption and code change via the menu:
MENU>RADIO SETTINGS>FUNCTION SETTINGS>ENCRYPTION
CODE
