Vehicle Battery Installation
1. Slide vehicle BATTERY DOOR open and remove as shown. (Fig. 1)
2. Insert 2 fresh, new Alkaline batteries into battery compartment as
shown. IMPORTANT: OBSERVE BATTERY POLARITY (DIRECTION, +
AND -). (Fig. 2)
3. Replace BATTERY DOOR and slide closed until it latches. (Fig. 3)
Remote Battery Installation
1. Slide open BATTERY DOOR on REMOTE and remove. (Fig. 4)
2. Insert a fresh, new 9-VOLT ALKALINE BATTERY with the polarity
(+/-) as shown on the bottom of battery compartment. (Fig. 5)
3. Replace BATTERY DOOR and slide it closed to secure. (Fig. 6)
Vehicle Operation
1. Turn on POWER SWITCH on bottom of vehicle. (Fig. 7)
2. Vehicle operates best on flat, smooth, surfaces. KEEP AWAY
FROM WATER, SNOW AND WET SURFACES.
3. If vehicle steers slightly to one side or the other when you
press a button to go straight, move the TRIM TAB on the
bottom in the opposite direction, a little at a time. (Drive vehicle
away from you to test.) Repeat if necessary. (Fig. 8).
Fig 7
Fig 8
POWER
SWITCH
TRIM
TAB
R/C Tip
In order to race or operate two vehicles together, they must
be different frequencies. Check the package and the bottom
of your vehicle for the frequency label.
Remote Operation
Press and hold a "dialing" button to move the vehicle in the direction
shown by the arrow on the button. Release button for "neutral."
Note: There is no on/off switch on Remote. Pressing the buttons turns it
on. Releasing the buttons turns it off.
Forward
Right Forward
Left Forward
Reverse
Right Reverse
Left Reverse
Left
Right
Fig 1
Fig 2
Fig 3
Fig 4
Fig 5
Fig 6
ANTENNA
Extend antenna fully for operation. Hold Remote so antenna points straight up
in the air. Don't touch during operation.
1
1
2
2
