Operating on Water
Fresh water only--not sea or salt water!
CAUTION: ADULT SUPERVISION IS STRONGLY RECOMMENDED WHEN OPERATING ON OR NEAR WATER OR ICE.
Important: Time the use of the hovercraft on water so you can recover it before the battery runs out! Run for only 5
minutes each launch with a freshly charged battery to be sure.
Launching
1.Turn hovercraft power on.
2.Hold hovercraft as shown. Make sure lift fan is at full speed and air bag skirt is fully inflated. Carefully place hovercraft on water. (Fig. 10)
Important: Lift fan must be operating for hovercraft to operate properly. Air bag skirt may fill with water if lift fan is not running.
3.When removing from water, remove battery door and battery pack, hold hovercraft as shown and shake out excess water. (Fig. 11) Dry hovercraft
after use with a clean soft cloth.
How to operate your Hovercraft
●
Before operating the hovercraft, turn the switch ON.
(The lift fan will operate and hovercraft will be in lifted position)
●
FORWARD
Push the LEFT stick up. Release to coast.
●
BRAKING/REVERSE THRUST
Push the LEFT stick down.
●
LEFT TURN
Push the LEFT stick up and turn the RIGHT stick to the left.
●
RIGHT TURN
Push the LEFT stick up and turn the RIGHT stick to the right.
Fig. 10
Fig. 11
