background image

1.Slide open the battery door on back of

Transmitter, pull it toward the direction shown
in the figure while pressing lightly on its
center.

2.Insert fresh/new 9-volt (6LR61) battery with the

polarity ( / ) as shown inside battery
compartment.

3.Replace Battery door.

3. BEFORE OPERATION

Turn the vehicle Switch on.

For Customers

When the vehicle is held up,
direction of control stick on the
transmitter will be opposite of front
wheel direction.
This is Taiyo’s new steering system.

* Front steering may not work

while holding up, since only small
power is required. It is not a
malfunction.

4. OPERATING YOUR VEHICLE

The following is the basic operation. Once you understand it, try to create your own technique.

BASIC OPERATION

For Customers

This vehicle is not equipped with trim adjuster. While driving the vehicle, it may steer slightly to left or right.
Please adjust the vehicle with control sticks.
Your vehicle will run really well on hard packed dirt, asphalt and other similar surfaces.

Hold your vehicle steady on the ground
(keep your fingers clear of the wheel
hubs). Gently guide your vehicle forward
while pushing the left stick forward.

ACCEL-TURN START

Set your vehicle on the ground, leaning on one of its side stabilizers. Push the left stick
forward to drive straight ahead.

* The vehicle may not start depending on ground conditions (e.g. slippery surface).

Please try the normal start when this occurs.

Fig 1

Fig 2

Fig 3

TRANSMITTER

NORMAL START

Braking

Forward

Right turn

Braking

Left turn

Fig 1

Fig 2

Summary of Contents for mini suzuki rm250

Page 1: ... that the positive and negative connections are correct After use make sure to turn off the power switch and remove the battery Do not allow the battery to be short circuited Also do not attempt to disassemble or heat the battery or put it into flame More Important Battery Information Start with all new batteries and always replace ALL 4 vehicle batteries at the same time Different type of batteri...

Page 2: ...der out of the vehicle 3 Insert 4 AA alkaline LR6 batteries into the battery holder with polarity as shown on the holder 4 Replace the battery holder in the vehicle 5 Rotate the latch until it clicks shut locking the holder in place For Customers Use only AA alkaline LR6 batteries Estimated run time for this vehicle 60 minutes Rider Battery Holder Detachable Rear Working Suspension Front Working S...

Page 3: ...ou understand it try to create your own technique BASIC OPERATION For Customers This vehicle is not equipped with trim adjuster While driving the vehicle it may steer slightly to left or right Please adjust the vehicle with control sticks Your vehicle will run really well on hard packed dirt asphalt and other similar surfaces Hold your vehicle steady on the ground keep your fingers clear of the wh...

Page 4: ...to change Product may differ from illustrations A309 US R C Facts 1 When batteries start to wear down vehicle may slow stop or refuse to respond to your control It s time to replace ALL 4 vehicle batteries and transmitter battery This is absolutely the 1 cause of problems 2 Your vehicle runs on either 27MHz frequency or 49MHz frequency see frequency labels on vehicle and transmitter In order to ra...

Reviews: