3. INSTALLATION
This chapter describes how you to install this mower.
Before starting the installation, read the previous
Read the whole of this chapter before starting the
installation. How the installation is made also affects
how well the mower will work. It is therefore important
3.1 Preparations
Training
- Read the instructions carefully. Be familiar with the
proper use of the mower.
controls and the
- Never allow people unfamiliar with these instructions
the mower. Local regulations
or children to use
- The operator or user is responsible for accidents or
to other people or their property.
hazards occurring
3.2 Hardware adjustments
Blade adjustment
The mowing system used by this mower is based on
an effective and energy efficient principle. Unlike
normal lawn mowers, the mower cuts the grass instead
Rain sensors on the mower is optional,suggest operate the
mower in dry weather to obtain best possible result.
Even
though the mower can mow in rain,wet grass
collects on mower easily and the risk of slipping
on steep slopes increases.
The blades must be in good condition to obtain the best
mowing result. In order to keep the blade sharp for as
long as possible it is important to keep the lawn free
from branches, small stones and other objects
3. INSTALLATION
chapter 2. Presentation.
the installation carefully.
to plan
may restrict the age of the operator.
of striking it off.
(especially the objects less than 6cm height). Please fill
up small holes and even out small mounds to make sure
lawn is flat.
How to adjust the cutting height:
Cutting height explanation: take 3cm level for example.
3.3 Charging station installation
- Choose best installation place, please make sure
no magnetic interference and no
it is flat, no water,
station.
obstacle in the front of charging
- Please fix the charging station on horizontal place and
Charging
station
best
install
place
:
1. Make
sure
it is flat
2. No
magnetic
interference
3. No
water and far away from puddle
4. No
obstacle
in
front of charging station
- Lay virtual wire
- Fix the charging
stakes by
IMPORTANT INFORMATION
Before locate the charging station, please make sure
mower must follow the virtual wire and back to
station in CLOCKWISE direction.
as picture shows.
station with four
IMPORTANT INFORMATION
Do not tread or walk on the charging station plate.
3CM
Grass
Height
Cutting height: 3cm
- 6 -
3cm
Peg
hammer.
1. Turn power off
3. Adjust cutting height device manually 2.5cm-5.5cm.
2. Use height adjustment spanner rotate knob clockwise.
4.
.
Use tool rotate knob anticlockwise
correct direction.
Cutting height adjustment knob
