3. INSTALLATION
3.4 Virtual wire installation
The virtual wire can be installed in one of the following
- Securing the wire to the ground with pegs.
It is preferable to staple down the virtual wire, if you
adjustments to the virtual wire during
want to make
- Bury the wire
It is preferable to bury the virtual wire(max depth: 5cm)
the lawn.
if you want to detach or aerate
If necessary both methods can be combined so one
wire is stapled down and the
part of the virtual
- Install virtual wire with pegs 1 meter apart. It’s
best to use smooth radius corners than sharp
- Bury virtual wire below grass and fasten it on
that the mower should
the ground with pegs, so
not cut the wire.
virtual wire
Add pegs in order to pull the
virtual wire down to the ground
surface, below the grass tips.
OK
IMPORTANT
INFORMATION
Hard or dry ground may cause pegs to break when
driving them in. In extreme cases, watering the lawn
ways:
the first few weeks of operation.
remainder is buried.
where the pegs will be driven.
- A minimum distances between the front of the charging
station and an
And make sure the
obstacle is 2 meters.
least
distance from corner to front of charging station is at
2.5 meters. Make sure to lay a 2.5 meters minimum
>90
10cm
Pool
Max:1cm
Passage or
a ground with
same level
of the lawn.
Min:40cm
Min:40CM
Min:40CM
Straight-line
at least:2.5m
House
,
wall, fence or
other
obstacle
higher
than the lawn
- If a high obstacle, for example a house, wall, fence or
other obstacle which is higher than the cutting lawn
prevent mower
at least 40cm from the obstacle. This will
Location
virtual wire in front of charging station.
straight-light of
the virtual wire should be laid
borders the working area,
with the obstacle.
from colliding
- If a passage or a ground with same height of cutting lawn,
the virtual wire should be laid at least 10cm from the edge.
- A minimum distance between the pool edge of virtual
wire is 40cm.
- A maximum distance of the virtual wire
to and from the island is 1cm, and fix the
- There are two types of set up of the
virtual wire around the charging station.
Put the charging station near corner.
please take location for reference.
Please make sure to set a straight-line
at least of 2.5m in front of charging
station. The charging station should be
far away from puddle.
- 7 -
two wires with one peg.
. See pictures.
angles
- A minimum distance between two corners is 1meter.
