3.4 Virtual wire installation
The virtual wire can be installed in one of the following ways:
- Securing the wire to the ground with staples.
It is preferable to staple down the virtual wire, if you want to make
adjustments to the virtual wire during the first few weeks of operation.
- Bury the wire
It is preferable to bury the virtual wire if you want to dethatch or aerate
the lawn.
If necessary both methods can be combined so one part of the virtual
wire is stapled down and the remainder is buried.
3. INSTALLATION
- Dig virtual wire with pegs 1 meter per piece in straight-line. Dig corner as
picture.
- Bury virtual wire below grass and fasten it on the ground with pegs, so
that the mower should not cut the wire. If the grass grow up, we can still
keep the virtual wire as before.
virtual wire
Add pegs in order to pull the
virtual wire down to the ground
surface, below the grass tips.
OK
3. INSTALLATION
- A minimum distances of front charging station and obstacle is 2 meters.
And make sure the distance from corner to front of charging station is at
least 2.5 meters. Make sure to lay a 2.5 meters minimum straight-light of
virtual wire in front of charging station.
45
°
Straight - line
at least 2.5 m
IMPORTANT
INFORMATION
The charging station is not water-proof,
It’s best to make a Rain Shed above the charging station.
Greater than
50cm
-
P20
-
-
P19
-
IMPORTANT
INFORMATION
Hard or dry ground may cause pegs to break when driving them in.
In extreme cases, watering the lawn where the pegs will be driven.
