6. MAINTENANCE AND STORAGE
6.5 Battery
The battery is maintenance-free, but has a limited life span of 1-3years.
Battery life is dependent on the length of the using season and how many
hours per week the robot is used. A long season or many hours of use per
week, means that the battery must be replaced more regularly.
- Attentions for lead-acid batteries
Charge the batteries at least once every six months of they are at 25
℃
The
interval
of
this
charge
should
be
reduced
to
5 0%
by
each
10
℃
rise
in
temperature
above
25
℃.
The
self
-
discharger
state
,
their
capacity
may
not
recover
ever
after
charge
.
If
the
batteries
are
stored for more than a year at room temperature. The life of batteries
may be shortened.
Store the batteries starting from fully charged state to prevent the life of
the batteries being shortened.
Use the batteries as quickly as possible after receiving them as they
gradually deteriorate even under proper storage conditions.
- Attentions of lithium batteries
Please charge the lithium batteries in accordance with standard time and
procedures.
When the power is too low. It should be started charging as soon as
possible.
Storage, we suggest the optimum storage of lithium battery is with 40%
power and keep in the shade.
- Disused battery processing
Please contact the nearest waste treatment certer and consultation with
recycling and proper disposal of views.
IMPORTANT INFORMATION
Charge the battery fully at the end of the season before
winter storage.
-
P45
-
After enter the
correct password
and set operate
patten, but the
mower still can
not start. And the
charging station
is beeping.
After enter the
correct password
and set operate
patten, but the
mower still can
not start
During operating,
Mower stop
cutting enter
taskstate, and
beeping
Users' hands
touch the handle
at the back of
mower.
Do not touch the
handle.
Restart the
mower .
1. No power to
plug receptacle
or main power is
shut off. Bad
communication
between
charging station
and mower
1. Check the
power and check
the plug.
Connect
charging station
with power
supplier.
1. The virtual
wire fails to send
signals.
2. The virtual is
broken
1.Check the
virtual wire light
(colorless). Be
sure the virtual
wire is connected
to the charging
station that is
motion, and there
is no loose place.
2. Connect the
wire with virtual
wire connectors.
7. TROUBLE SHOOTING
7. Trouble shooting
1 6°
C
FRI
1 2 / 1 7
0 9 :0 2
BEEN CUT OFF
ALAM
16°
C
FRI
12/17
09:02
VIRTUAL WIRE HAS
ALAM
1 6°
C
FRI
12/ 17
0 9 :0 2
CHARGING STATION
ALAM
1 6°
C
FRI
1 2 / 1 7
0 9 : 0 2
OUT OF POWER
ALAM
-
P46
-
Problem
Display
Solutions
Possible reasons
1 6°
C
FRI
1 2 / 1 7
0 9 : 0 2
HANDLE TOUCHED
ALAM
