2. PRESENTATION
- Mowing schedule
Set up one week (From Monday to Sunday, once for each day) cutting
schedule from control panel. The mower is on auto pattern when in
schedule functioned, if it feels is powerless, it will go back to charging
station for recharge automatically, and it will goes on cutting after it
finishes recharge.
- Anti-theft function
User must enter the correct password then the mower can be started.
What's more, the mower can not be turned on without charging station.
- Cutting width:30cm
- Humanistic cutting height selection
3cm-6cm humanistic design.
Easier for user to choose the cutting height. Just screw it!
- Auto recharge system
When the mower is operating it feels powerless, the cutting motor turn off
at once and it will find the virtual wire then go alone it back to charging
station for recharge automatically. (this allows you to keep the charger
connected with the charging station all the time, even after the battery is
fully charged.) On auto pattern, the mower will go on mowing after fully
recharge. But if it is on manual pattern, it will just stay on charging station
after fully recharge.
- Emergency stop switch
There is an emergency stop switch located on the top of mower and red in
color. If you press it in any case during operating, the mower must stop all
movement and stop the rotating of blades immediately. Rotating the
switch to reset it and the mower is in taskstate by entering the correct
password and choose operate pattern to restart it.
- Two cutting modes
There are two cutting modes of the mower, go straight and go circle (high
efficiency). On manual pattern, we can choose the cutting mode from
remote control. On auto pattern, mower selects cutting mode intelligently.
It goes straight if the grass has be cut, and it goes circle if the grass is
long.
-
P10
-
6. MAINTENANCE AND STORAGE
7. To remove the deposits and/or other residues from the blade, use a
suitable brush.
8. Clean the outside of the charging station from any accumulated
residues.
9. Keep all nuts, bolts and screws tight to be sure the appliance is in
safe working condition.
10. Replace worn or damaged parts for safety.
11. Ensure that only replacement cutting means of the right type are
used.
12. Ensure that batteries are charged using the correct charger
recommended by the manufacturer.
13.Incorrect use may result in electric shock, overheating or leakage
of corrosive liquid from the battery.
14. In the event leakage of electrolyte flush with water/neutralising
agent, seek medical help if it comes into
contact
with
the
eyes
etc
.
15. Servicing
of
the
appliance
should
be
according
to
manufacturers
instructions
.
This
product
(
include
battery
pack
)
must
be
disposed
of
at
a
designated
collection
pint
for
electrical
and
electronic
waste
.
For
more
information
,
contact
your
local
city
office
or
the
shop
where
you
purchased
the
product
.
3.Clean all the outside surfaces of the robot with a spong soaked
in
warm
water
.
4.Do not use solvents or benzene so not to
damage
the
varnished
surfaces
and
the
plastic components.
5.Do not wash the inside parts of the robot and do not use water jets in
pressure so not to damage the electric and the electronic
components.
6.Check the lower part of the robot (cutting blade area and wheels)
and remove the deposits and/or residues that might obstruct the
correct functioning of the robot.
WARNING
Never use a high-pressure washer or
even running water to clean the robot.
-
P43
-
