Table of contents
Chapter 5 Functions concerning embroidery
To change thread breakage detecting sensitivity (Thread Detection) ......................... 77
To trim thread by the number of consecutive jump stitches (Jump Convert)............... 79
To add thread trimming code to the design and trim thread (Data Edit "Insert") ......... 80
To change maximum speed only in some section (Revolution Limit).......................... 84
To decide upper limit value of the maximum speed (Max. Revolution Limit).............. 85
To stop the machine automatically when reaching the set value (Preset Halt) .......... 86
To stop the machine before needle bar hits the frame (Software Frame Limit).......... 87
To stop the machine with needle bar stuck in the material (Stop at Lower D.Point) ... 89
To perform enlargement, rotation, reversion (Data Conversion) ................................. 92
To change stitching condition in every needle bar (Setting in units of Needle bar) ... 101
Summary of Contents for TEMX-C Series
