To decide the design start position
61
1
2
3
4
5
6
7
8
9
10
11
Chapter 4
RR07
(2)
To execute
When the tracing is impossible due to the design size exceeding the embroidery space, follow the procedure
below.
(a)
The frame will move again after stopping temporarily.
(b)
Code No.225 will be displayed.
Press E key.
(c)
After checking the size of the design, move the frame to the design start position.
(d)
Perform tracing again.
To interrupt trace, follow the procedure below.
(a)
Suspend the operation by the bar switch or the stop switch.
Code No.1C1 will be displayed.
While a code No.1C1 is displayed, do not turn OFF the power.
(b)
Press E key.
(c)
After that, follow the message described below.
Low
"YES">>SET
"NO">>E
OK to continue Tracing?
To continue => SET key
To suspend => E key
Summary of Contents for TEMX-C Series
