To adjust finishing of sewing
100
Chapter 5
RR07
7-2-2.
How to operate
The following is an example that applicable range is set to "part" and adding amount is set to "+0.4".
(1)
To open screen
(2)
To select applicable range
(3)
To select adding amount
7-3.
To divide a long stitch (Auto Jump)
This function makes the frame movement to divide by jump automatically when a stitch length exceeds a
setting value. This function reduces the load generated at the frame drive due to heavy weight of the material
to be embroidered. However, dividing by jump will reduce embroidering efficiency.
7-3-1.
Explanation on the screen
3 Satin Stitch
Part
+0.4
2 Auto Jump
F1
4.0
240
240 360[ ]
NO/2.0
[mm]
9.9
NO
YES/NO
Frame Drive
Keep up R.p.1M.
Setting for auto jump
NO: Not to perform
2.0 to 9.9:
The machine will jump automatically when a
stitch exceeding a set value is given. When a
value is 4.0, the machine will jump automatically
if stitches of 4.1 mm and more are given. If
frame type is set to “Auto Clamp Frame”, setting
range is 2.0 to 5.0 mm.
R.p.1M. at auto jump
Yes: To keep (remaining in high speed)
NO: Not to keep (speed reduction according to a stitch length)
Timing to start moving the frame (p.105)
Start Timing
Summary of Contents for TEMX-C Series
