To adjust finishing of sewing
107
1
2
3
4
5
6
7
8
9
10
11
Chapter 5
QS07
7-7-2.
How to operate
The following is an example that remaining length of upper thread is set to "B" after start sewing.
(1)
To open screen
(2)
To select remaining length of upper thread after start of sewing
7-8.
To adjust stitching length according to a stitch length (Frame drive adjustment)
This function corresponds to the multi-head machine only.
7-8-1.
Explanation on the screen
Stitch length tends to be increased in [-] value and decreased in [+] value in general due to
characteristic of the machine. However, this aptitude may not be applicable depending on setting
condition of other items and/or machine condition.
10 Upper Thread Lock Timing
B
0
3 Frame Drive Adjustment
Frame Type Tubular
X 4mm
12mm
Y 4mm
12mm
0
0
0
-3 +3
-3 +3
-3 +3
-3 +3
Set
F2
[a]
"Frame Type" selected now (p.141).
The following values can be memorized at
every "Frame Type".
[b]
[c]
[d]
[e]
To adjust stitch in crosswise direction of
around 4 mm finely
Stitch in crosswise direction of around 12 mm
Stitch in lengthwise direction of around 4 mm
Stitch in lengthwise direction of around 12 mm
-3
+3
0
Increase
Decrease
Summary of Contents for TEMX-C Series
