To increase embroidering efficiency
109
1
2
3
4
5
6
7
8
9
10
11
Chapter 5
QS07
8.
To increase embroidering efficiency
8-1.
To change number of lowering needle bar at slow operation (Number of inching times at
start)
This function targets slow operation when the machine stops in the middle of embroidery and then the
machine restarts. Regarding the number of lowering the needle bar by slow operation at start after thread
trimming or after data set, refer to the detail page. (p.74)
8-1-1.
Explanation on the screen
8-1-2.
Explanation for operation
The following is an example that the number of Start Inching is set to "3".
(1)
To open screen
(2)
To select number of lowering needle bar at slow operation
8-2.
To collect up frame moving amount of consecutive jump stitches in a batch to feed the
frame all at once (Jump code combination)
This function corresponds to the multi-head machine only. It reduces the number of stitches by combining
frame moving amount of consecutive jump stitches (up to 5 stitches) and by feeding the frame all at once.
8-2-1.
Explanation on the screen
4
Number of lowering needle
bar at slow operation
3 Main Shaft Inching
3 Main Shaft Inching
4
3
NO
YES: To set
NO: Not to set
5 Jump Code Combination
Summary of Contents for TEMX-C Series
