Safety Precautions
2
Chapter 1
RR07
1.
Safety Precautions
1-1.
Warning
To prevent accidents resulting in injury or death and physical damage, the following items must be observed
strictly when operating the machine.
This machine is designed for industrial use. Use this machine for semi- or finished textile
products and similar materials. Using the machine for other purposes must be avoided.
Do not stand on the machine.
For the machine model with the bar switch, using the bar switch as a grip to support
yourself is strictly prohibited.
Do not use a device such as a cellular phone that generates microwave near the control
circuits of the power supply box, the operation panel box, etc. Microwave may cause
malfunctioning of the machine.
Do not remove the covers for the shaft and the pulleys. Also, do not run the machine
without the covers.
Do not put your hands, etc. access to the vicinity of
needle during operation. Sticking of needle could
injure you.
During operation, do not access your hands and/or
face to moving sections. Especially, it is dangerous
around needle, rotary hook, take-up lever, pulley and
speed-reduction box.
This machine used strong magnet. The person, who is mounted with internal implantable
medical electronics like a pacemaker, should not use this machine. The person who is
mounted with an equipment described above also should not access to magnet inside of
this machine. This internal equipment could malfunction.
Please read this book thoroughly and understand
the contents of operation certainly. Then, operate
the machine.
Wear proper clothes and tidy up yourself so that you
can smoothly perform the operation.
A single operator should operate the machine in
principle. If plural operators are working together,
make sure that no one is working near the moving
units of the machine before starting the machine.
Use the machine under the environment where
access can be supervised so that unauthorized
person does not operate the machine. Supervise
children so that they do not access to the machine.
Only the persons who are sufficiently trained for the operation must operate the machine.
The rear of the machine is not a working area. If you have to move to the rear of the
machine, make sure to turn off the main switch.
!
WARNING
Summary of Contents for TEMX-C Series
