To return the frame to the original position
145
1
2
3
4
5
6
7
8
9
10
11
Chapter 6
QS07
3.
To return the frame to the original position
3-1.
To return the frame that was moved to the original position (Manual Offset)
This function is effective only when the frame is moved manually after stopping the machine in the middle of
embroidery.
3-1-1.
Explanation on the screen
3-1-2.
How to operate
The following is an example of executing manual offset.
(1)
To open screen
(2)
To perform manual offset
When performing this operation, do not put your hands etc. on the machine table. Moving
frame could injure you.
5 Manual Offset
To return the frame to the
original position
: To execute
: Not to execute
!
CAUTION
5 Manual Offset
Pressing SET will move the frame.
Summary of Contents for TEMX-C Series
