To return the frame to the design start position
151
1
2
3
4
5
6
7
8
9
10
11
Chapter 6
QS07
4.
To return the frame to the design start position
4-1.
To return the frame to the design start position manually
(Return to the design start position)
This function makes the frame return to the design start position in the middle of embroidery when you
stopped the machine.
4-1-1.
Explanation on the screen
4-1-2.
How to operate
The following is an example of executing design start position return.
(1)
To open screen
(2)
To execute design start position return
When performing this operation, do not put your hands etc. on the machine table. Moving
frame could injure you.
4 Return to the design start position
To return the frame to the
design start position
: Not to execute
: To execute
!
CAUTION
4 Return to the design start position
Pressing SET will move the frame.To return
to the original position, perform "Manual
Offset". (p.145)
Summary of Contents for TEMX-C Series
