To move the frame to the position registered
155
1
2
3
4
5
6
7
8
9
10
11
Chapter 6
RR07
5-2.
To move the frame automatically at the start, in the middle
and the end of embroidery
This function is the setting to move the frame automatically so that replacement of the frame, works for
applique and change of fabric to be stretched can be performed easily.
The following is an example of movement when the settings of "Auto Color Change (AC)" and
"Automatic Thread Trimming" are "YES".
(1)
At the start of embroidery, the frame will pass from the offset start position [A] through the offset middle
position [B] and move to the design start position [C] by the operation of the bar switch or the start switch
(described as switch operation hereinafter), then the embroidery will start.
(2)
During embroidery, the frame will pass from the color change point [D] through the offset middle position
[B] and return to the offset start position [A]. After performing works for applique here, the frame will pass
through the offset middle position [B], move to the color change point [D], then start embroidery by switch
operation.
(3)
When embroidery is finished, the frame will pass from the design end point [E] through the offset middle
position [B] and return to the offset start position [A].
5-2-1.
Explanation on the screen
[A]
[C]
[B]
[B]
Embroidery starts
During embroidery
[E]
[A]
Completion of embroidery
[D]
2 Needle Bar Selection
1
2
3
4
5
6
5
3
4
2
1
3
B
Offset mark
After step 2 is finished, the frame will return to
the offset start position [A] automatically. To
move the frame, the setting of "Automatic
offset" is necessary. (p.153)
If "Automatic Offset" is not set, the frame will
move to the design start position [C].
Summary of Contents for TEMX-C Series
