How to use each part
22
Chapter 2
QS07
2-5.
Main shaft handle, Color change handle (Single-head machine only)
2-5-1.
Color change handle
Turning this handle by hand will cause the needle bar case to slide. It is possible to slide the needle bar case
only when the main shaft angle is set to the fixed position. Fix the handle at the position where the screw
faces directly above (odd-numbered needle) or directly below (even-numbered needle).
2-5-2.
Main shaft handle
Turning this handle by hand will cause the needle bar to lower.
When turning this handle with the power ON, follow the procedure below.
(1)
Press F3 key while pressing SET key.
(2)
Select “2 Weak brake”, and press Set key.
(3)
Select “NO” in the below screen, and press SET key.
Main shaft handle
Color change handle
Screw
NO
100
YES / NO/ Always NO
[ ]
NO
Current main shaft angle
2 Weak brake
SET
F3
+
Summary of Contents for TEMX-C Series
