Turn ON the power
36
Chapter 4
QS07
1-2.
Turn ON the power
(1)
After turning on the power, the screen will switch as the figure below. Wait for a while until the power
starts up.1
(2)
When the power starts up, the following message will appear. Then, press SET (This message will not
be displayed in multi-head machine).
When performing this operation, do not put your hands etc. on the machine table. Moving
frame could injure you.
Award modular BIOS ********
***************
***************
***************
***************
***************
Press DEL to set up
*********************
Software version installed in the machine
will be displayed.
>> Now System Loading...40[%]!!
Windows CE.net
Microsoft
TEMX-C
Press SET.
The frame will move and return to the original position.
TAJIMA_W
14117
0
Frame origin memory
"YES" >> SET
This operation is for grasp of the frame position
correctly and it is displayed every time when the
power is turned ON.
This message will be displayed only when
"Frame origin memory with the power-ON" is set
to "YES".(p.149)
When this message is not desired to display, set
to “NO”.
TAJIMA_W
14117
0
If the screen (main screen) as shown left is
displayed, preparation is completed.
is performed.
!
CAUTION
Summary of Contents for TEMX-C Series
