To decide the design start position
55
1
2
3
4
5
6
7
8
9
10
11
Chapter 4
QS07
5.
To decide the design start position
5-1.
To check the design size and the setting contents of the design (Check of design)
Check setting conditions such as size, scale up/down, repeat, etc of the design to be embroidered from now.
Use the checking result as rough standard when deciding the design start position.
This function will be explained in detail on the other page (p.30).
5-1-1.
Explanation on the screen
5-1-2.
How to operate
(1)
To open screen
Press i key.
Current position
Stitch Counter
Function
Stitch Length
Design Counter
Step
OFFSET
Data conversion
Rotation
Reversion
Repeat
M. Repeat
0
88.4
0.0
-59.6 59.2
(From Design
1/ 8
3.
10. 5. 7. 2
7
8. 4.
80
3
3
-130.0
pp
0.0
G0041
W-Tajima
14117st
80
100.0
0.0
0
0
Design to be embroidered
Repeat of design
Enlargement/reduction/
reversion of design
Size of design (mm)
88.4
-59.6
59.2
Start position of design
The size based on the design start position
after scaling up/down will be displayed.
This example shows the size of lengthwise
88.4 mm and crosswise 118.8 mm.
Start Point)
from now
After pressing this key again, setting contents in detail and the code No. occurred
up to now can be confirmed.
To return the main screen, press E key.
Summary of Contents for TEMX-C Series
