To decide the design start position
56
Chapter 4
PT10
5-2.
To lower the needle bar to adjust the frame position (Needle bar operation)
This function corresponds to the multi-head machine only.
5-2-1.
Explanation on the screen
5-2-2.
How to operate
The following is an example when lowering the needle bar.
(1)
To open screen
(2)
To lower the needle bar
When performing this operation, do not put your hands etc. near the needle. Moving up/
down of the needle bar could injure you.
Up: To raise the needle bar
Down: To lower the needle bar
10 Needle bar operation
Up
!
CAUTION
10 Needle bar operation
Up
When pressing the SET key, needle bars of
all heads will move down.
Down
Summary of Contents for TEMX-C Series
