To stop the machine
86
Chapter 5
PT10
4.
To stop the machine
4-1.
To stop the machine automatically when reaching the set value (Preset Halt)
4-1-1.
Explanation on the screen
[a]
The machine will stop when counting reaches the number of set stitches (display of 1D2).
[b]
The machine will stop when embroidery stitch length reaches the set length (display of 1D2).
[c]
The machine will stop when the number of designs reaches the set numbers (display of 1D2).
[d]
The machine will stop when counting reaches the number of set stitches (display of OIL).
When automatic lubrication system is set to "YES", it will not be displayed.
[e]
The machine will stop short of the end code by one stitch (display of 1D2).
YES: To stop
Since embroidery is not finished, it is possible to perform frame back.
NO: Not to stop
[f]
Quantity of beads attached to Lochrose embroidery device (option) at left
When the equipped beads run out, the machine stops (display of 1D5).
To disable this function, select "NO". This setting will be displayed when "Lochrose embroidery
device" is set as "L" or "L + R" (p.182).
[g]
Quantity of beads attached to Lochrose embroidery device (option) at right
The contents are same as above.
6 Preset Halt
C
Stitch
0
0
0
10
NO
0-999999[st]
Data
0-99999[cm]
Design
0-999[Designs]
Lubrication
0-99*10000[st]
Just before
YES/NO
300
300
Lochrose (L)
Lochrose (R)
[a]
[b]
[c]
[d]
[e]
[f]
[g]
To stop at number of stitches (1 stitch unit)
To stop by stitch length
To stop by number of designs
To stop at number of stitches (10000 stitch unit
To stop just before end of design
To stop by beads quantity at left
To stop by beads quantity at right
end code
Summary of Contents for TEMX-C Series
