Option buttons (top middle).
COORD: To rotate the design. P and one blinking light is normal. Press STEP to change to 45
degree mode (two blinking lights). Press SET to make it stop blinking.
A.CHNG: To switch between automatic and manual color change.
A.STRT: To turn on automatic start after a color change.
FRAME: To allow frame to be moved manually during sewing.
D.SET: Press after you have chosen a new design, and have finished with options.
Edit buttons (bottom right)
NUMERIC KEYPAD 0-9: Manual color change immediately. Also to insert values.
STEP: To browse through menu options
C: Clear button.
MODE: To change a parameter.
ERASE: Used in the memory erase function
MRY: Memory Erase button; used in the erase-all function
Main menu list
N.SELECT
: To show the current automatic color sequence
TAPE CODE
: To show the loaded design
REPEAT
: To show the repeat settings
STITCH
: To show the stitch count. Press C to reset the count.
REPEAT
: To show the repeat settings
ERROR
: This menu is shown only when there is an error. Press RESET to clear.
ALL LIGHTS
: To show the current resize/scale setting.
Status lights
STOP P.
: Lights up when your main shaft is at the STOP position, marked in RED on the
flywheel.
JUMP, STOP, END
: Lights up when you are at a JUMP code, STOP code, or END code.
Bar switch and button (under table)
BAR SWITCH LEFT: Pull bar to the left to stop, or to go back one stitch
BAR SWITCH RIGHT: Pull bar to the right to start; same as the green buttons.
INCH BUTTON: Inching or Jog button. This is NOT an ATH button.
Frame move
ARROW KEYS: Cause the frame to move manually.