Load a new design
1. Press TAPE CODE.
2. Press the 2 key and then press SET.
3. The blinking number is the first empty memory location for your new file.
4. Change this number, or leave it. Press the SET key when done.
5. Press the D.SET key. This will start the download from tape process.
6. Completion! Be sure to set a new offset for this memory location or it will use the old one.
Select a design in memory
1. Press TAPE CODE.
2. Press the 5 key and then press SET.
3. Choose a design by typing in the number.
4. Press SET when you have the number you want.
5. If you want to rotate the design, you do it now. Press COORD to rotate, and press SET when done.
STEP will change between rotating 90 degrees (one blinking light) or 45 degrees (two blinking lights).
6. Press D.SET to continue with the process.
7. The screen will ask for a resize value. Accept the standard 100% value by pressing SET.
8. Make sure your offset is programmed or cleared, or the frame will move where you don't expect.
9. To clear offsets, Press MODE, then 4, then SET.
10. Choose a start point with your manual arrow keys. Do NOT press SET again, or that will be the
offset.
11. You are ready to start sewing!
Setting color change
1. Press the SELECT button.
2. The first color change will be chosen for editing, and the current color selection is blinking.
3. Press the number keys to choose a new color.
4. Press STEP to confirm, and move to the next color.
5. If the E is blinking, then no color has been chosen yet. Pick a color and press STEP.
6. When you wish to stop, choose a number and press SET instead of STEP.
7. Finished! Don't forget the automatic color change and auto-start buttons, if you want it to be active.
