34
Page
<Mounting and Wiring the Remote Controller>
1. Take off the
Back plate
from the remote controller with a flat head screwdriver.
(Fig. A and B)
2. Attach the
Back plate
on the wall with the two provided screws.
(Fig. B)
3. If you use another cable, crimp the
Fork terminals
to the wires. (
Fig. C)
Installation
Installation Manual
Fig. B
Back plate
3-1/4 inches
Attach the screws
Cut out the partition with pliers.
(removed during later steps.)
Main body
Fig. A
Main body
Twist
Press and twist flat head
screwdriver against the cutout.
Remote controller cable
1-3/8 Inch
(35 mm)
Fig. C
1-5/8 Inch
(41 mm)
Fork
Terminals
-Installation-
•
This remote controller is NOT waterproof.
•
The water heater can only have one remote controller.
•
Do not install in high temperature environments, high humidity conditions outdoors, in
direct sunlight, or within the reach of children.
•
Make sure the remote controller does not come into contact with water or oil.
•
Failure to observe these warnings could result in personal injury or electrical shock.
WARNING
•
Do not place the remote controller cable close to other wires from other products.
•
Cables used for the remote controller connection must be:
•
Minimum 20
gauge wire (No polarity)
•
Maximum 400 ft (122 m) long
NOTICE
4. Tighten the two
Fork terminals
beneath the two
Remote controller
terminal
screws on the back of the main body.
(Fig. D-1)
5. Cut out the inlet for the remote controller cable from the bottom of the
main body.
(Fig. D-2)
6. Place the
Main body
back on the
Back plate
, with the
Remote controller
cable
running out of the bottom inlet.
firmly fixed. (See the above instructions for installation
of the remote controller.)
5. Pull the remote controller cable through the hole at
the bottom of the water heater’s casing.
6. Secure both controller cable terminals to the
terminals on the computer board as shown below.
(Secure them underneath the screw terminals. No
polarity.)
* Do NOT jump or short-circuit the cables, or
computer will be damaged.
7. Replace the front cover securely.
<How to connect the remote controller to the water heater>
1. Disconnect power supply from the water heater.
2. Take off the water heater’s front cover.
3. Locate the two terminals for the remote controller in the water heater. (Refer to the Fig. E-1.)
4. Take off the back plate from the remote controller, and then attach the two fork terminals to the
connector base on the back side of the remote controller with two screws. Make sure the terminals are
Remote controller
terminals
Fig. D-1
Two fork terminals
Remote controller cable
Inlet for the remote
controller cable
Cut out
Fig. D-2
Fig. E-1
100209924
(TM-RE42)
Connect other end to these terminals
