OPERA
TION
On-Demand Water Heater Installation Manual and Owner’s Guide
65
-
Information mode-
You can get some information about the water heater condition by pressing the
"INFO"
button. For more informa-
tion, follow the procedures below:
Operation
Controllers
Built-in controller
Remote controller
1.
Press the
"INFO"
button on the controller to enter the
information mode.
2.
Press the
"INFO"
button to display the inlet water
temperature.
Inlet water temperature
(EX.: 60°F)
3.
Press the
"INFO"
button again to display the outlet
water temperature.
4.
Press the
"INFO"
button again to display the water flow.
5.
Press the
"INFO"
button to exit the information mode.
Outlet water temperature
(EX.: 120°F)
Water flow
(EX.: 3.5 GPM)
NOTICE
When installed on an indoor heater, the 100276687 (TM-RE43) has priority for set temperature
over the built-in controller.
-Unit of measure conversion-
Units of measure can be changed from Imperial to Metric and vice versa. For example, temperature can be
changed from °F to °C. Flow rate will also change from gallons per minute to liters per minute when this setting is
changed. Follow this procedure to change this setting:
Operation
Controllers
Built-in controller
Remote controller
1.
Press the
"ON/OFF"
button on the controller in order to
turn the controller on.
2.
When ON, the STAND BY LED is lit.
3.
The current set temperature and time will be
displayed on the screen.
4.
Press the
"INFO"
buttons for at least 3 seconds.
5.
The set temperature should now be displayed in the
alternate unit of measurement.
(EX.: 120°F)
(EX.: 50°C)
OPERATION
Controller settings
Summary of Contents for 160X3P
Page 84: ...7J8071 1 2000570774 REV B...
