- 43 -
OPTIONAL ITEMS
1. Temperature remote controller: 9007603005
(TM-RE30)
The
temperature
remote
controller has two functions. It
allows the output temperature
from the water heater to be
adjusted within the range of
100 °F to 185 °F, and it also
works as a diagnostic tool that
will give a concise error code
whenever there is a problem with the unit. The
temperature options are 100 °F, 105 °F, 110 °F,
115 °F, 120 °F, 125 °F, 130 °F, 135 °F, 140 °F, 145 °F,
150 °F, 155 °F, 160 °F, 165 °F, 170 °F, 175 °F, 180 °F
and 185 °F. See the troubleshooting section for
information on possible error codes.
2. Multi-unit controller: 9007675005 (TM-MC01)
9008300005 (TM-MC02)
The multi-unit controller can
control a maximum of 10 water
heaters, from 15,000 BTU to
3,800,000 BTU. It also works as a
diagnostic tool that will give a
concise error code whenever there
is a problem with the unit.
The multi-unit controller comes
with a remote controller.
3. 5” Backflow preventer and F-F adaptor:
9008202005
There are two functions available for
this adaptor which can be connected
with the water heater and NovaVent
venting line and prevents the backflow
of air through the exhaust vent. This
helps prevent harmful exhaust gases
from entering the home, as well as
helping to prevent the unit from
freezing in areas where cold air can
be blown or drawn into the exhaust
system. Install this adaptor in accordance with the
installation instructions that are packaged with the
adaptor and any applicable codes.
4. Vent cap: 9007677005 (TM-VC50)
The vent cap is for
outdoor installation with
the 910 (T-M50) water
heater.
The cap is
installed on the top of
the unit, instead of
connecting an exhaust
vent pipe. The cap will
prevent any debris that might be in the environment
from entering the unit and causing damage or a fire
hazard, as well as preventing rain or other weather
from entering the unit.
5. Direct-vent conversion kit: 9007669005 (TM-
DV50)
This kit can be used to convert the
910 (T-M50) from a conventional vent
system to a direct-vent (or sealed
combustion) system. This is a CSA
tested conversion kit. Install this
conversion kit in accordance with
the manufacturer’s installation
instructions and any applicable
codes.
6. Pipe cover: 9007673005 (TM-PC50)
The pipe cover protects the
plumbing pipes to the 910
(T-M50) from unexpected
adjustments. This pipe cover is
fixed to the bottom of the water
heater, which hides the plumbing
and improves the visual aspects of
the whole installation for the water
heater.
7.
Sidewall vent terminator (Hood) and Wall thimble:
They are used when venting out through the wall. These terminations are special
stainless steel vents for gas applications and are UL listed as Categoly ll, lll and lV.
For different wall thickness, there are two ranges of lengths available. (Refer to the
NovaVent brochure for details.) Install these vent terminations in accordance
with their installation instructions
and any applicable local codes.
Part #
Covering wall thickness
9008347005
Wall Thimble 4”-7”
9008348005
Wall Thimble 5”-10”
9008197005
Terminator Hood
Terminator Hood
Wall Thimble
