O p e r a t i o n Pr o c e d u r e s
16
Setup conditions excluding mode change can be changed
during the operation.
[Changing the conditions during operation]
When correct radiation becomes not possible due to
the misalignment of the customer's head position
during operation, the infrared temperature sensor
detects the situation to initiate the warning
electronic alarm at intervals of 30 seconds. Tell the
customer to move back into the correct position. If
the operation is continued with the head position
misaligned, the expected finish may not be achieved.
[Warning of Head Position Misalignment]
(For COLOR, PERM, and TREATMENT modes)
Press the Start/Stop button during operation to stop
ring rotation and heater control, and the Start/Stop
lamp blinks. The pilot lamp (condition indication)
changes to blinking from illumination.
During interrupted operation, the setup condition
can be changed. When the mode is changed, the
operation mode shifts to the changed mode, and the
operation is in the standby state.
Press the Start/Stop button within five minutes after
interrupting the operation to resume operation. If
the Start/Stop button is not pressed within five
minutes, the mode will reset to the mode before
starting operation.
[Interrupting the operation]
6
Cooling
8
After completing the operation, be sure to
turn off the power switch.
When the preset time has elapsed and the time
indication is zero (0), the cooling operation will be
implemented.
※For the setup of ring rotation and stop, the setup
condition can be changed only for manual mode.
7
Timeout
When the preset time has elapsed and the time
indication shows 0, the electronic alarm indicating a
timeout will be initiated, and the heater and the
pilot lamp will go OFF. The ring will stop at the
home position.
Specification w/o Fan
The equipment will enter the cooling process
for one minute.
* During the cooling operation, the ring will
rotate when the heater is OFF.
* No cooling operation is executed for the
ring‑fixed operation in manual mode.
Specification w/ Fan
The equipment will enter the cooling process
for two minutes.During the cooling operation,
cold air will be blown from the fan.
* In manual mode, the fan will not operate
during the cooling process, and as is the
case with the specification w/o fan, the
cooling time is one minute.
After the timeout, the retention time will be
indicated by a blinking lamp.
[Counting the retention time]
The retention time after timeout is displayed up to
60 minutes. When the Start/Stop button is
pressed during this time, the setup that was used
last will be displayed. (This function is useful when
checking the preset time and the practice result in
comparison.) The memorized data becomes invalid
when the mode is changed.
[Memory Function]
