![background image](http://html1.mh-extra.com/html/takara-belmont/esthe-place/esthe-place_operation-manual_3322876013.webp)
3
Lowering the legrest
F
B
4
Raising the backrest
Step on the upper side of the BACK switch on the foot control to raise the backrest.
While you are holding it down, the backrest will keep rising.
F
B
BACK switch (lower side)
the chair to their preset positions (see page 14).
■
Shockless motion
Step on the lower side of the LEG switch on the foot control to lower the legrest.
While you are holding it down, the legrest will keep going down.
LEG switch
(lower side)
●
Before lowering the legrest, make sure that there is no person (or animal) underneath it.
The chair operates at low speed when entering into motion and coming to a halt. This “shockless motion” function
controls vibration during operation and achieves smooth motion and quiet operation. To make full use of this function,
please note the following:
○
Warm-up mode
This chair is controlled by hydraulic power. Due to the shockless motion function, the positions the chair parts come
to a halt at may vary slightly with the temperature of the hydraulic fluid and the weight of the customer sitting in the
chair.
Especially on winter mornings when the hydraulic fluid is very cold, the shockless motion function is activated to such
a degree that the chair parts may come to a halt at very different positions from their intended positions. To deal with
this matter, the chair has a warm-up mode. When the hydraulic fluid is very cold, turning on the power switch starts
the warm-up operation to warm the hydraulic fluid.
The warm-up operation takes 3 minutes. While in the warm-up mode, an alarm will keep sounding. To turn off the
mode midway, step on any switch on the foot control. The warm-up operation will be cancelled, and you can operate
the chair as usual.
○
Because of the shockless motion function, the chair parts may not come to a halt exactly in the intended positions,
depending on the hydraulic fluid temperature and the customer’s weight. If the preset switches do not bring the chair
exactly to the set positions, such as completely flat, and you have difficulty providing beauty salon services, you can
change to the positioning mode, which ensures precise part positioning.
To change to this mode, refer to the “Turning on positioning mode” section (on page 14).
WARNING
This chair has a preset function. Just stepping on one of the preset switches automatically moves the specific parts of
To adjust preset positions to ensure flatness or other parts positioning
13
Summary of Contents for ESTHE PLACE
Page 22: ...NOTE...
Page 23: ...NOTE...