![background image](http://html1.mh-extra.com/html/takara-belmont/spa-mist-ii-ak-160/spa-mist-ii-ak-160_operating-instructions-manual_3323830019.webp)
Release the stopper and loosen the strip.
Pull off the leading edge of the flexible hose
from the cap joint N.
Raise the customer's head, and remove the
mist cap and the turban.
Unfasten the hook and loop fasteners of the
mist cap and the turban.
Detaching the mist cap
This completes the installation of the mist cap.
Water drops accumulate in the
mist cap. Be careful about water
dripping from the cap.
Information
CAUTION
・Be sure to drain the water in the flexible hose into the bowl
after use.
・Be careful not to bend or twist the flexible hose.
・Use of the machine without draining the water in the flexible
hose or with the hose bent or twisted may make it difficult to
atomize the mist or may result in machine failure or accidents
due to increased temperatures.
Be sure to drain the
accumulated water after
each operation.
CAUTION
Inner cap joint N
Cap joint N
Insert the leading edge of the flexible hose into the cap joint N. At this time, be careful not to twist
the mist cap, and insert the flexible hose with the [UP] mark of the inner cap joint N facing UP.
(See the section "Preparation" on page 9.)
※If the flexible hose is hard to insert, apply water to the inside of the plug‑in portion of the
flexible hose, which will make your work easier.
7
6
1
2
3
4
17
Do not use the machine with the mist cap crushed by the
flexible hose. Ignoring this precaution may result in mist that
will not be atomized correctly, the customer will feel sick, or
the customer will get burned.
Summary of Contents for SPA MIST II AK-160
Page 2: ......