29
Adjusting the volume of water
Shower head
Tap
Close
Open
Turning the tap to the left (anticlockwise) will output
water from the shower head.
The volume of water will increase as the tap is
turned left.
The maximum volume of water will be output when
the tap is turned full left.
Turning the tap full right (clockwise) will turn the
water off.
Caution
- When not in use, turn the tap securely to the rightmost position (clockwise) to
ensure the warm water stops.
Failure to completely stop the water may cause water leak accidents.
- After the completion of work, do NOT block the drain port with the trap cap, towels,
or shampoo cloths.If the water accidentally flow or a small amount of water flow due
to the increase of water pressure at night while the trap cap is covered, water leak-
age may occur.
Failure to take this precaution may result in contact between the metal and the tap
resulting in flaws or cracks on the plated surface and thereby causing peeling of the
plating.
- When the water discharge flow becomes slow, the discharge pipe may be clogged
with waste or the like. In such a case, immediately stop using the product and call the
Call Center.
- Check that there are no flaws, cracks, or peeling of the plated surface of the knobs
before using the product.
If peeling is observed, immediately stop using the product and contact your local
Takara Belmont dealer. Continued operation may result in injuries.
- The tap may become stiffer when turned depending on the environment or condition
that it is used in.
This is due to deterioration of gasket of movable parts or a lack of grease as a result
of aging.
- Depending on the usage environment or conditions, the flowing water sound may be generated from
the basin. This phenomenon occurs as water flows fast in the pipe when some condition, such as
hydraulic pressure and adjustment of hot water amount is met, and is not a product defect. The
flowing water sound may be reduced by adjusting the hydraulic pressure.
- The tap may become stiffer when turned depending on the environment or condition that it is used in.
This is due to deterioration of gasket of movable parts or a lack of grease as a result of aging.
Replacement of the gasket or other parts, or a recoating of grease is required.
