Takara Belmont YUME SWING, Operating Manual

23

Kerosene

Alcohl

Thinner

Wax

Abrasive

Chemicals

■

Neck Cushion, Head Pillows

■

Hair Catcher

Care and Maintenance

Never use volatile chemicals such as thinners, alcohol, gasoline or kerosene, cleaning products such as abrasive 

wax, a sponge with a scourer, detergents that include organic solvents, acidic, alkaline or chlorine-based deter-

gents, or scouring pads. Failure to follow this instruction may cause scratches or discoloration.

Clean the hair catcher as regularly as possible. Continuing to use the hair 

catcher without cleaning can cause the drain to become blocked with 

hair, leading to water overflowing and unhygienic conditions. Try to clean 

the hair catcher after each shampoo.

・

If solvents drip onto the neck cushion or head pillows, rinse it with water as soon as possible. Failure to follow this 

instruction may cause deformation or discoloration.

・

Clean the neck cushion and head pillows every day. Leaving dirt unclean may cause them to get moldy.

Pull out the hair catcher located under the drain cap and remove any hair that 

has been caught. The hair catcher is a consumable supply. Replace the hair 

catcher if it is extremely dirty or the surface has deteriorated. 

(available at additional cost)

At the end of work each day, wash the neck cushion and head pillows with water, wipe them dry with a towel, and 

allow them to dry in the shade. If they are extremely dirty, wash with detergent diluted with water, and rinse carefully 

with water.

The neck cushion and head pillows are consumable supplies. Replace them if they are extremely dirty or the surface 

has deteriorated. (available at additional cost)

Caution

Caution

Caution

Drain Cap

Hair Catcher

Drain outlet

・

Repeated usage of even general domestic-use sponges may damage the surface.

Therefore do not use sponges.

・

Abrasives, as well as sponges containing abrasives, metal scourers, nylon scourers, etc.

May damage the surface. Ensure that these are not used.

・

Do not use chlorine chemicals and acid chemicals because they may peel the surface

plating.

・

If scratching or damage appears on resin or plated parts such as the tap and thermostatic control knob, then 

immediately suspend use, and contact the closest dealer or Takara Belmont. Failure to suspend use may result in 

peeling plating or damage, leading hand injuries.

■

Shower head holder, Tap, Thermostatic control knob

 Wipe away contamination using a soft cloth or towel that has been moistened with a dilute, neutral detergent.

Caution