DISASSEMBLY AND ASSEMBLY
SLEW MOTOR
3
4
SLEW MOTOR
4N0AX00
Disassembly and assembly
General precautions
• Perform disassembly and assembly work in a clean
place. Provide clean containers to hold parts during
disassembly.
• Before disassembly, clean around the ports and re-
move coating or thread-locking compound on the
joints with a wire brush.
• Clean disassembled parts with dedicated cleaning oil.
• Apply hydraulic oil on the sliding surfaces and thin lay-
er of grease on the seals before assembly.
• Replace seals with new ones after each disassembly.
• Check each part for abnormal wear or seizing. Re-
move any burrs with sandpaper.
Disassembly
1. Take out the socket bolts, and remove the break
valve.
• Place the shaft downward, and secure the flange
section in place with a vice before starting disas-
sembling.
2. Take out the bolts, and remove the valve housing.
3. Take out the valve housing, and remove the balanc-
ing ring (5) and valve (6).
• Make sure not to lose the spring (7) and the pin (8)
for the balancing ring.
Summary of Contents for TB215R
