Takstar E126W, Manual

③ Volume Control: press “+” once to increase microphone volume, or “−”

once to decrease.

④ Sync/Power Indicator: when powered up, this indicator is off when the 

headset microphone is out of battery; flashes blue when microphone is low 

on battery. It also flashes blue during frequency sync after you press and hold

 “M”, or during frequency change after you press “M” once.

⑤ Charging Indicator: illuminates red during charge, goes off when fully 

charged.

⑥ Charging Port: accepts Micro USB charging cable for charging the 

microphone.

Operation Instructions

I. Frequency Sync

1. Sync Frequency

The product is synced by default before shipping out the factory, and will 

automatically connect to each other without extra sync operation. In case of 

signal interference, you can re-sync or change the frequency following the 

below steps.

① First, turn on the headset microphone. When the blue mic LED is lit, press 

and hold the “M” button on mic for 3s until the blue LED blinks. Then 

immediately turn on the amplifier, wait till the mic LED stops blinking and 

stays lit, and speak to the microphone. If synced successfully, you should 

hear your voice from the amplifier.

② If you cannot hear your voice from the amplifier when speaking to the 

microphone, please retry the above syncing step.

12

PORTABLE WIRELESS AMPLIFIER

E126W