Takstar E500W, User Manual

④ 

Play/Pause button: press it to play or pause the music. When playing in 

Bluetooth, long press this button to disconnect Bluetooth, followed by a voice 

prompt “Bluetooth disconnected”; long press this button again to reconnect 

Bluetooth, followed by a voice prompt "Bluetooth connected". When playing 

music in TF card mode or USB mode, long press this button to loop a single song, 

accompanied by a single loop symbol       ; long press this button again to cancel 

single-song loop, and the symbol       will disappear.

⑤

Next track button: press to switch the next track.

⑥

Previous track button: press to switch to the previous track.

⑦

MIC input interface: insert a wired mic to start wired voice amplification.

⑧

AUX input interface: connect to a playback device (e.g., phone, tablet, 

MP3 player) via a Ø3.5mm audio cable, so to use the amplifier as an active 

speaker.

⑨ TF card slot: insert a TF memory card following the labeled direction until you 

hear a click to install it in place. To remove the TF card, press it down until it clicks

to eject the card.

Tip: Please make sure the audio files in the TF card are stored in MP3 and/or 

WAV format, otherwise it won't be readable and may even damage the device. 

Please format the TF card to FAT16 or FAT32 file system before copying songs, 

because other file system (e.g., exFAT, NTFS) will cause failure to save recordings 

or play songs.

⑩ USB interface: insert a USB flash drive to play audio files.

⑪

  Charging port: charge the amplifier via a Type-C charging cable.

⑫

  Strap clip: used to install the shoulder strap for wearing the amplifier across 

shoulder.

 Wireless Amplifier

E500W

14