Takstar E500W, User Manual

If the amplifier is not powered on within 10s after the mic enters pairing 

mode, the mic will exit pairing mode and its LED circle will change back to 

a static number.

 No sound when talking to the headset mic means the pairing is not 

successful, please retry.

2. Changing Frequency

①

power up both devices at the same time. Press the mic [M] button to change 

frequency, and the channel number on headset LED display will flicker. Then, 

press volume [+]/[-] button to cycle through frequency, and press [M] again to 

confirm frequency, or leave it auto confirmed after 3s idleness.

Make sure that the headset mic and the amplifier are already paired, then 

B. Bluetooth Pairing

Upon first use, you need to connect this device to your phone or Bluetooth device, 

following below steps:

①

Power up the amplifier, press [M] to switch to Bluetooth mode and start 

Bluetooth discovery and pairing, indicated by a blinking “BLUE” symbol.

② Enter SETTINGS menu on your phone, find and enable Bluetooth, wait 

until “TAKSTAR E500W” is discovered and tap on it to connect. When 

connected successfully, there will be a voice prompt about “Bluetooth 

Connected”. Devices such as cell phones, laptops, tablets, and iPads can 

play music via Bluetooth thereafter.

③ The next time you switch to Bluetooth mode, the amplifier will 

automatically connect to the previously paired device, signaled by a voice 

prompt “Bluetooth connected”.

 Wireless Amplifier

E500W

18