Installation 3
Taktis Fire Control Panel - Installation Manual
Man-1154-In, Revision E01.02
80 of 156
Installing Addressable Devices
This section describes installation requirements and constraints for addressable devices on the Taktis Fire
Control Panel. The addressable devices described in this section include detectors, addressable sounders and
I/O modules.
Detector Spacing
Install addressable detectors with minimum spacing requirements specified in AS1670.1 or other local codes
of practice.
Detector Sensitivity
Detector sensitivity can be set at different levels and for certain periods. Sensitivity levels should be
determined and planned in advance.
Activation Period
Detector sensitivity and calibration can be set once in a twenty-four hour period. A setting is also available for
limiting the annunciation time of the sounder assigned to the detector.
Reference Section 4, Operation for functional details concerning the Activation Feature of the Taktis Fire Control
Panel:
Detection Loop Sounders and Output Boards
Install addressable sounders so not more than one sounder zone is affected by a fault condition. Install
detection loop devices of the Taktis Fire Control Panel containing one of the following methods to meet this
requirement:
•
Perform an addressable loop installation that does not contain output devices.
•
Perform an addressable loop installation where output devices are in one zone.
•
Perform an addressable loop installation where output devices are in different zones.
Loop installations require that an isolator is fitted to every twentieth loop device in the circuit.
Connecting Sounder Circuits
The Taktis Fire Control Panel includes four programmable sounder outputs S1, S2, S3 and S4. Each of the
sounder outputs is capable of operating 24V DC circuits at 2.5A. The sounder outputs are set to operate
continuously in any fire condition as a default condition. All sounder outputs can be configured to operate in a
different configuration as described in the programming section of this manual.
Sounder outputs can be configured in pairs for loop circuit operation. Loop circuit operation can be assigned
to a single pair such as S1, S2 or both sounder outputs containing pairs S1, S2 and S3, S4.
For Spur operation, the end of line device fitted in the terminals of the control panel must be removed from
the panel and fitted across the terminals of the last device on the sounder circuit.
Wiring of the sounder circuit must be sized according to the cable-length and the sounder load to ensure that
voltage drop of the cable does not exceed the minimum operating voltage of connected-devices.
Different limitations will apply for devices with a higher or lower minimum operating voltage.
Reference Appendix A, Specifications for Sounder Cabling.
Summary of Contents for Incite Fire S3
