Installing the Light Kit 8.
WARNING:
Shut off the power supply
before removing or replacing lamp.
1.Remove the finial from the light kit
stem.
2.Place the light kit stem to the light
plate, secure with 2 screws.
3.Connect the wire connector from the
fan to the lamp, then install the lamp
(40W) to the light plate using the two
lamp holders to prop up the lamp. Be
sure to pull the lamp holders out a
l i t t l e f o r i n s t a l l i n g t h e l a m p
easier.(Figure 13)
4.Place the glass shade in the glass
holder, then raise the glass holder up
against the light plate and secure it to
the fan with finials.(Figure 14)
5. Reattach the finial to the light kit
stem.
6. Restore power and your light kit is
ready for operation.
7. If the light kit does not work, turn off
t h e e l e c t r i c i t y a n d l o w e r e i t h e r
canopy or decorative housing on your
ceiling fan to make sure the blue, gray
a n d p u r p l e w i r e s a r e c o n n e c t e d
Figure 14
Glass
Glass
holder
Finial
Screw
Figure 13
Light kit
stem
Lamp
Lamp
holder
Wire
connector
Finial
