background image

Talamex inflatable boats – User’s manual 

Pagina 17 van 17 

 

7. 

Warranty 

LIMITED WARRANTY 

I. We guarantee each new production Talamex inflatable 
boat and accessories attached thereto (hereafter referred to 
as “Product”) to be free from defects in material and 
workmanship, but only when the consumer sale is made in 
a country to which distribution is authorized by us. 
II. The warranty shall become effective only after digital 
registration, which should happen 2 weeks after purchase 
at last. The product will be registered by a serial number 
This warranty shall remain in effect as described below. 
A. For Talamex Highline and S-Line boats, a 3-year 
warranty of the hull fabric against cracking, porosity and 
rot, is valid. The material of all the other Talamex boats are 
covered by a 2-year warranty against cracking, porosity 
and rot.  
B. Hull seams, end cones and rubbing strakes of Talamex 
Highline and S-Line boats are covered against 
delaminating by a limited 3-year warranty, where hull 
seams, end cones and rubbing strakes of all other Talamex 
boats are covered against delaminating by a limited 2-year 
warranty. 
NOTE: Seams are determined to have delaminated when 
the outer coating separates from the fabric base or the seam 
loses its structural strength. If delamination occurs on only 
one seam and not on the entire boat, the seam is to be 
repaired under warranty. 
C. The aluminium hull are covered by a limited 2-year 
warranty (Silverline and TLRA models). 
D. All other boat parts, including but not limited to 
components such as oarlocks, handpumps, seatbenches, 
boat bag, valves, transom holder, transom, D-rings, 
stringers and floor boards are covered by a limited 2 year 
warranty. 
III. Exclusion of this warranty: 
Since this warranty applies only to defects in material and 
workmanship, it does not apply to normal wear and tear, or 
to damage caused by: 
A. Neglect, lack of maintenance, accident, abnormal 
operation, improper installation or services, or prolonged 
exposure to sunlight and (salt) water; 
B. Use of an accessory or part not manufactured or sold by 
us; 
C. Participating in or preparing for racing or other 
competitive activity; 
D. Alteration or removal of parts; such as drilling holes in 
the transom; 
E. Use of an outboard motor with a higher capacity and/or 
weight than the capacity plate indicates; 
F. Charter, rental and commercial use; 
G. Damage as a result of force majeure including, but not 
limited to overloading, abnormal water, wind and weather 
circumstances, etc. 
H. Incorrect use like, but not limited to, incorrect 
harbouring, beaching, towing, mooring, lifting, collision, 
incorrect use of a trailer; 

I. Damage as a result of theft or fire; 
J. Damage caused by rainfall from the sky, tree juices, 
spilling of chemicals, use in polluted areas; 
K. Normal abatement, wear, discolouration, dullness and 
aging of cloth, metal, wood and plastic; 
L. Damage or abatement of cosmetic surfaces like tears, 
hair cracks, discolouration, hallowed spaces, fading or 
oxidation of the powder coating; 
M. Osmotic blistering or tears in the powder coating 
including spider shaped tears; 
N. Costs of normal maintenance and cleaning; 
O. Consequential damage or incidental damage; 
P. Moisture damage to wooden parts as a consequence of 
not maintaining a protective coating for these parts. 
Q. Damage caused by use of cleaners, other than advised 
elsewhere in this manual. 
IV. This warranty does not cover incidental or 
consequential costs or expenses such as: haul–out, launch, 
towing transport and storage charges; telephone or rental 
charges of any type, inconvenience, or loss of time or 
income; or other consequential damages. 
V. Customer must provide reasonable access to the product 
for warranty service by delivering the product for 
inspection to a Talamex dealer authorized to service the 
purchaser’s product. Purchaser shall pay for all related 
transportation charges and/or any other expenses 
associated with that service. Any product or parts shipped 
by purchaser for inspection or repair must be shipped with 
transportation charges prepaid. Digital registration, in 
combination with the purchasing account, is the only valid 
registration identification and must be presented at the time 
warranty service is required. Warranty claims will not be 
accepted when boat is not timely registered. 
VI. Our obligation under this warranty shall be limited to 
repairing a defective part, or at our option, refunding the 
purchase price or replacing such part or parts as shall be 
necessary to remedy any malfunction resulting from 
defects in material or workmanship as covered by this 
warranty. We reserve the right to improve the design of 
any product without assuming any obligation to modify 
any product previously manufactured. 
VII. This warranty gives you specific legal rights, and you 
may also have other legal rights that vary from country to 
country. 
VII. Transfer of warranty: the limited warranty is 
transferable to a subsequent purchaser, but only for the 
remainder of the unused portion of the limited warranty. 
This does not apply if the vessel is used for rental or 
commercial use. Unexpired warranty coverage can only be 
transferred to a subsequent purchaser upon proper 
registration of the product. To transfer warranty please 
register boat digitally.

 
 

 

Summary of Contents for QLS200


















Reviews: