TALARIA POWER TECH (CHONGQING) CO., LTD.
XI. Maintenance Service
— 50 —
Checking the drive chain
1. Remove the key from the ignition switch, as well as to switch off the circuit breaker.
2. Using a ruler, grasp the chain halfway between the front and rear sprockets.
3. The chain shall have a tension of 15mm–25mm.
4. If the chain’s free play is not within specifications it will need to be adjusted.
Adjusting the drive chain
Note:
Adjust both sides equally.
1. Remove key from the ignition switch and switch off the circuit breaker.
2. Loosen the rear axle nut on right side of the electric motorcycle.
3. Loosen the (left and right) M6 jam nuts.
4. Turn the (left and right) M6 adjustment bolts 1/4 turn at a time
until the chain adjustment is within specification.
5. Tighten left and right jam nuts to secure the chain.
6. Tighten the axle nut on right side of moped. Torque 75 lb·ft (102 Nm).
7. Test ride the electric motorcycle.
8. Recheck the chain for proper adjustment after the test ride and readjust, if necessary.
Chain
M6 jam nut
M6 adjusting bolt
Rear axle nut
50