a
CCessories
installation of universal Harness - orbital Shaker
1. Unit should be in standby mode.
2. Remove non-skid rubber mat.
3. Insert one band through the side of the “U” in the U-shaped cut-outs on the center
post. Pull band through to secure to the U-shaped cut-out. Repeat for the three
remaining bands.
4. After the bands are installed in the center post, line up the holes in center post with
the two holes in middle of the tray. Using the screws provoded, hand tighten into
place using a flathead screwdriver. DO NOT over tighten.
5. Place the sample(s) on tray.
6. Stretch the harness bands over the sample(s) and then under each of the bent-down
corners of the tray.
not for use with the Microplate Shaker.
univErSAL HArnESS
P
latforM
P
art
D
esCriPtion
M
iCroPlate
C
aPaCity
C
aPaCity
n
uMber
Universal Harness
2 or 4
1
980192
installation of 2-Bar Adjustable Platform - orbital Shaker
1. Unit should be in standby mode.
2. Remove non-skid rubber mat.
3. Line up the holes in the 2-Bar Adjustable Platform to the holes in the tray.
Using the screws provided, hand tighten into place using a flathead screwdriver.
do not over tighten.
4. Add glassware. Adjust rollers by loosening each of the thumbscrews. Slide the
padded rollers to the desired position and retighten the thumbscrews.
not for use with the Microplate Shaker.
2-BAr AdjuStABLE PLAtForM
The 2-Bar Adjustable Platform has a non-skid rubber surface with adjustable clamping
bars to accommodate various vessel types. Stainless steel construction.
P
latforM
P
art
D
esCriPtion
s
ize
(l
x
W)
C
aPaCity
n
uMber
2-Bar Adjustable Platform
11.7 x 8.7” (29.7 x 22.1cm)
1
980197
14
