Operating Conditions: Indoor use only.
Temperature:
4 to 40°C (39.2 to 104°F)
Humidity:
20% to 85% relative humidity, non-condensing
Altitude:
0 to 6,562 ft. (2000 M) above sea level
Non-Operating Storage:
Temperature:
-20 to 65°C (-4 to 149°F)
Humidity:
20% to 85% relative humidity, non-condensing
Installation Category II and Pollution Degree 2 in accordance with IEC 664.
e
quiPment
D
isPosal
This equipment must not be disposed of with unsorted waste. It is your responsibility
to correctly dispose of the equipment at life-cycle-end by handing it over
to an authorized facility for separate collection and recycling. It is also your
responsibility to decontaminate the equipment in case of biological, chemical
and/or radiological contamination, so as to protect the persons involved in
the disposal and recycling of the equipment from health hazards.
For more information about where you can drop off your waste of equipment, please
contact your local dealer from whom you originally purchased this equipment. By doing
so, you will help to conserve natural and environmental resources and you will ensure
that your equipment is recycled in a manner that protects human health.
Upon receiving the Talboys’ Vortex Mixer, check to ensure that no damage has
occurred during shipment. It is important that any damage that occurred in transport
is detected at the time of unpacking. If you do find such damage the carrier must be
notified immediately.
After unpacking, place the Vortex Mixer on a level bench or table, away from explosive
vapors. Ensure that the surface on which the unit is placed will withstand typical heat
produced by the unit. Always place the unit on a sturdy work surface.
The Vortex Mixer is supplied with a power cord that should be plugged into a properly
grounded outlet. If the supplied power cord does not meet your needs, please use an
approved power cord that suits local codes and electric supply. Replacement of the
plug must be made by a qualified electrician.
m
aintenance
& s
ervicing
The Vortex Mixer is built for long, trouble-free, dependable service. No lubrication or
other technical user maintenance is required.
The unit should be given the care normally required for any electrical appliance. Avoid
wetting or unnecessary exposure to fumes. Spills should be removed promptly. DO
NOt use a cleaning agent or solvent on the front panel which is abrasive or harmful to
plastics, nor one which is flammable. Always ensure the power is disconnected from
the unit prior to any cleaning. If the unit ever requires service, contact your Talboys’
representative.
i
nstallation
e
nvironmental
c
onDitions
2
