TALEX Sp. Z O.O. Sp.K.
ul. Dworcowa 9C
77-141 Borzytuchom
tel. (59) 821 13 26.
English mob.: +48 507 828 310
e-mail.
biuro@talex-sj.pl
www.talex-sj.pl
User Manual
FastCUT 300 Disc Mower
Page
15
of
56
4. Intended use of the machine
The disc mower is designed for mowing all low stem green plants in meadows and fields
on
even and unstoned areas.
A front disc mower is not resistant to
stone impact
. If the work is carried
out on a stony tillage area, this can result in the frequent
replacement of
blades and discs.
In extreme cases, the
cutting bar can be damaged
, which
is not covered by the warranty.
This machine allows you to significantly accelerate agricultural work through high mowing
performance and even distribution of swaths. Such swath arrangement accelerates drying and
eliminates additional measures, such as spreading the swath after mowing.
The mower is a category II front-mounted three-point hitch machine of a tractor with a
minimum output of 80 HP. The drive is provided by an articulated telescopic shaft and the
hydraulic system with an actuator which sets the position of the mower during operation.
Rotating discs fitted with blades are the service parts. This unit is driven by the telescopic
articulated PTO shaft, through a central gear, then through the telescopic articulated shaft to a
bevel gear, and from the bevel gear through a coupling to the cutting bar. The cutting bar
contains a gear unit that transfers the drive to the disks.
Complying with the requirements for the use of the machine, its operation and repairs strictly
according to the manufacturer's guidelines is the condition for the use of machine as intended.
The machine should be used, operated and repaired only by persons familiar with its specific
characteristics, who have learnt the rules of conduct prescribed by the occupational health and
safety regulations.
The manufacturer offers a wide range of agricultural machinery. It can also provide professional
advice in terms of choosing the right equipment for your needs.
Any doubts concerning the machine’s intended use should be resolved by contacting its
manufacturer.
Selecting the right device and knowing its intended use makes its
operation safer.
Using the machine for any purpose other than the intended one will be considered to be
improper use.
