TALEX Sp. Z O.O. Sp.K.
ul. Dworcowa 9C
77-141 Borzytuchom
tel. (59) 821 13 26.
English mob.: +48 507 828 310
e-mail.
biuro@talex-sj.pl
www.talex-sj.pl
User Manual
FastCUT 300 Disc Mower
Page
19
of
56
6. Machine operation
The manufacturer guarantees that the machine is fully operational and has been checked in
accordance with quality control procedures and approved for use. However, this does not
relieve the user from the obligation to inspect the machine after its delivery.
Each time the machine is to be used, check its technical condition, especially for the
condition of cutting unit, drive transmission system, hydraulic system and guarding
shields
.
6.1. Coupling – mounting the mower
Make sure that the connecting parts of both, the vehicle and the machine, are suitably
adjusted to each other.
In case of any doubt, always ask the vehicle or the machine manufacturer.
I
. Installation of the suspension system of the vehicle and the machine.
The machine is mounted on a three-point hitch suspension system of the tractor. For easier
coupling, set the bottom tie-rods, (2) in Fig. 4, to the height of ca. 350mm.
Fig. 4 Coupling the mower to the tractor
