TALEX Sp. Z O.O. Sp.K.
ul. Dworcowa 9C
77-141 Borzytuchom
tel. (59) 821 13 26.
English mob.: +48 507 828 310
e-mail.
biuro@talex-sj.pl
www.talex-sj.pl
User Manual
FastCUT 300 Disc Mower
Page
26
of
56
7. Operation and maintenance
All the machine operations can be performed by the operator of the vehicle, to which the
machine is attached, providing he/she has proper authorization to operate this vehicle.
After uncoupling the machine from a vehicle, it must be disassembled and stored
under shelter on a flat and hard surface, on its parking support.
Before connecting the machine to a tractor, the operator must always check the condition of
the machine and prepare it for trial start, for which follow the procedure below.
•
Read carefully this manual and follow the guidelines contained herein
•
Learn and understand how to operate the machine
•
Perform visual inspection of all components of the machine for any mechanical damage
•
Lubricate the machine in accordance with the recommendations
•
Check the mechanical condition of the pins in the hitch system and of the cotter pins
•
Check oil level in the gearbox
•
Check the direction of rotation of the external disks
•
Check the condition of the bolted joints
•
Check the condition of the cutting blades, replace worn ones in pairs
Use only the original spare parts provided by the manufacturer, to guarantee
safe and reliable operation of the machine. The use of not original spare parts or
parts, which have been repaired, will void the warranty.
If all the above listed steps have been performed, and the mechanical condition of the machine
does not raise any doubts, it can be connected to the tractor.
•
Set the machine to the working position.
•
Adjust the length of the articulated telescopic shaft for the tractor according to the shaft
manual.
•
Connect the articulated telescopic shaft to the tractor and mower.
•
Start the drive.
Run the mower drive for 3minutes. During this time, check if
•
You can hear any irregular noise in the drive system.
•
You notice any vibrations in the cutting unit.
