TALEX Sp. Z O.O. Sp.K.
ul. Dworcowa 9C
77-141 Borzytuchom
tel. (59) 821 13 26.
English mob.: +48 507 828 310
e-mail.
biuro@talex-sj.pl
www.talex-sj.pl
User Manual
FastCUT 300 Disc Mower
Page
27
of
56
7.1 Ensuring the correct direction of rotation of the mower discs
Before mowing, switch the PTO shaft drive of the tractor to anticlockwise rotations. The direction of
rotation of external service discs is correct when the discs rotate inwards, if you look from the side of
the mowing direction, see Fig.13.
Fig.13 Correct direction of rotation of external discs
Note!!! If the tractor does not support the anticlockwise switch of the PTO shaft rotations,
follow the instructions below
If the tractor does not come with the switch of the direction of rotation, follow the procedure below to
turn the central gear unit by 180 degrees:
1.
Remove the PTO shaft from the central gearbox, (1) in Fig.14
2.
Unscrew the eight M16x35 bolts, (2) in Fig. 14
3.
Raise the mower by approx. 100 mm on the three-point hitch so that you can safely remove the
gear unit.
4.
Rotate the gear unit by 180 degrees as shown in Fig.14
5.
Remove the PTO shaft guard, (1) in Fig.14, and swap its position with the position of the gear
plug guard, (2) in Fig.14
6.
Tighten the eight M16x35 bolts referred to in item 2.
7.
Mount the PTO shaft on the central gear unit, (1) in Fig.14
Cutting direction
