TALEX Sp. Z O.O. Sp.K.
ul. Dworcowa 9C
77-141 Borzytuchom
tel. (59) 821 13 26.
English mob.: +48 507 828 310
e-mail.
biuro@talex-sj.pl
www.talex-sj.pl
User Manual
FastCUT 300 Disc Mower
Page
3
of
56
NOTE!
Before using the machine, please read thoroughly this Instruction Manual and observe the
safety instructions contained herein.
The Instruction Manual constitutes an inherent part of the machine!
Keep the Instruction Manual in a safe place, where it should be accessible to the machine
operator during an entire lifespan of the machine.
In the event of its loss or damage, the user must acquire a new copy from the machine dealer
or manufacturer.
In the event the machine is sold or made available to another user, the Instruction Manual
must be attached with the declaration of conformity for the machine.
The manufacturer reserves its copyrights to the Instruction Manual.
Make sure the first time you change oil in the transmission and bar is after
the first
50 hours of
operation of the mower.
After that, change oil every
500 hours
of operation.
Each time you finish work,
wash the cutter bar thoroughly with water
under pressure
so as to prevent the next start of the bar from being
blocked by dry mass stuck to it.
The machine features an appropriately
selected articulated telescopic
PTO
shaft. Using a different shaft will void the warranty, pose a threat to both
the machine and the area, and can damage the mower.
