TALEX Spółka z ograniczoną odpowiedzialnością Sp. K.
ul. Dworcowa 9C
77-141 Borzytuchom
tel. (59) 821 13 26
by email.
The Instruction Manual
LEO 320 PROFESSIONAL shredder
Page
16
of
37
5.2.
Leo 320 Professional shredder transportation position
Due to the large dimensions, exceeding the permissible transport width, the shredder cannot
be transport in the working position. According to the traffic law regulations, the shredder must
be pulled behind a tractor, using an additional hitch.
The picture below shows the shredder in the parking position.
When in the parking position, the machine should rest on the support feet (pos. 1, pos. 2) and
on the ground wheels (pos. 3). If we want to transport the shredder, the additional transport
hitch must be deployed (pos. 4). The transport hitch should be deployed and set in a horizontal
position. Use the adjustable support (pos. 2) to adjust it. After levelling out the hitch, adapt the
length of the central coupler (pos. 5). The next step is to close any covers and check if the
transport wheels (pos. 3) are locked in the correct position, as well as if all the pins are secured
from moving by means of safety pins.
After performing the control activities, when everything has been checked, aggregate the
tractor with the machine. After the aggregation, lift the supports (pos. 1, pos. 2) up and secure
them from dropping. Remember to use the warning triangle when moving on public roads.
Remember that after the shredder has been transported to the workplace, the transport hitch
needs to be set in the working position, the additional transport wheel (pos. 3) must be lifted
up and the ground wheels moved into the required working position.
The position of the additional transport hitch during work
5
3
1
2
4
