TALEX Spółka z ograniczoną odpowiedzialnością Sp. K.
ul. Dworcowa 9C
77-141 Borzytuchom
tel. (59) 821 13 26
by email.
The Instruction Manual
LEO 320 PROFESSIONAL shredder
Page
5
of
37
2.
Rules of safe operation
2.1 User safety
The shredder can only be used by adults, who have learnt its operation and read this
instruction manual, and are properly qualified. The shredders should be operated with all
necessary precautions, in particular:
In addition to this instruction manual, also observe the general rules of health
and safety at work.
Observe warning symbols placed on the machine.
It is strictly forbidden, to operate the machine by persons under the influence of
alcohol or other intoxicants.
Never allow the vehicle towing the shredder to be driven by a person other than the
shredder operator, and under no circumstances allow any other persons to be on the
vehicle, or by the machine, during its operation.
The shredder may be operated by an operator licensed to drive the vehicle onto which the
shredder has been mounted, in line with the recommendations of its manufacturer.
The operating position of the operator, while working with the shredder, is the cabin of
the vehicle to which the machine is attached.
Please note, that there are many elements of the shredder that may cause an injury (sharp
edges, protruding parts, etc.). While using the equipment, exercise particular caution
when moving close to the above-mentioned critical spots and obligatorily use the
following personal protection equipment:
-
protective clothing,
-
protective gloves,
-
protective footwear.
It is forbidden to carry persons or objects on the machine.
It is forbidden that the machine should be operated by persons who are not
familiarized with the instruction manual.
The person operating the shredder should be provided with a first-aid kit containing
measures for first aid, along with instructions regarding their use.
Take special care when driving on public roads, and comply with the applicable road
traffic regulations.
When driving on public roads, it is essential to use the electric outline lighting of the
vehicle, check its efficiency and visibility, and keep it clean. On the machine or on the
rear of the vehicle a triangular plate must be fitted, distinguishing low-speed vehicles.
Care should be taken about clarity and visibility of the reflective lighting and warning
signs located on the structural elements of the machine.
The transportation speed should be adjusted to the condition of a road surface, it should not exceed
however 20km/h.
Do not leave the vehicle with the shredder on a hillside or other sloping surfaces, without
